QSC CX168 User Manual page 31

SPECIFICATIONS
AMPLIFIER PROTECTION
COOLING
INDICATORS
CONNECTORS
LOAD PROTECTION
OUTPUT CIRCUIT TYPE
POWER REQUIREMENTS
CURRENT CONSUMPTION @ 120 VAC, typical
(both channels driven) in Amperes
Idle
1/8 power, 8 ohms*
1/8 power, 4 ohms*
1/3 power, 8 ohms*
1/3 power, 4 ohms*
NOTE: 1/8 power is representative of current draw with typical music program material with occasional clipping. *Pink noise
1/3 power is representative of program material with severe clipping.
CONTROLS
DIMENSIONS
WEIGHT
CX168
Full short circuit, open circuit, thermal, ultrasonic and RF protection.
Stable into reactive or mismatched loads.
Continuously variable speed fan; back-to-front air flow through tunnel heat sink
Front Panel: POWER LED (green), 8 each (1 per channel) SIGNAL (green) and CLIP (red) LEDs
4 each (1 per channel pair) BRDG LED (yellow), 4 each (1 per channel pair) PAR LED (orange)
Input: (8) 3-pin terminal block ("euro" or "Phoenix")
Output: (2) 8-pin detachable terminal block connectors
Control & Monitoring: (4) QSC DataPort connectors
Turn-on/turnoff muting
AC coupling (DC fault blocking)
Clip limiting
AB + B
SEE SERIAL NUMBER LABEL ON REAR PANEL FOR THE SPECIFIED OPERATING VOLTAGE
Configured at factory for either 100, 120 or 230 VAC, 50- 60 Hz.
0.6
6.2
9.2
9.2
14.2
Front: AC POWER switch, (8) gain controls
Back: (4) DIP switch blocks with 10 poles (1 per channel pair): Clip Limiters, Stereo/Parallel/Bridge mode
selection, low frequency filter on/off and frequency selection.
19.0" (48.3 cm) wide, 3.5" (8.9 cm) tall (2 rack spaces)
14" (35.6 cm) deep (from front mounting rails) including rear support ears
21 pounds ( 9.5 kg) net, 27 pounds ( 12.3 kg) shipping
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
31