Security Plate For Gain Controls - QSC CX168 User Manual

OPERATION:
GAIN CONTROL SECURITY PLATE
Gain Control Security Plate
After final gain adjustments have been made, the gain controls can be covered with a security plate. This easy-to-use security plate
makes it difficult for others to adjust the gain. This may be desirable in instances where the gain controls should not be tampered with. To
install the security plate:
1.
Use a 9/64" or 3.5mm hex key to loosen
the screw. Do not remove; just loosen sev-
eral turns.
2.
Orient the panel as shown and slide the right end
of the plate under the screw.
When properly installed, the security panel will still allow you
to monitor all the channel status LED's and power LED. The
amplifier front panel will look like the illustration, right, after
installing the security plate.
3.
Line up the tabs with the keyed portion of the
ventilation slots, insert into the slot and then slide
the panel fully right, locking it in the slot.
4.
Make sure the LED's are visible, then tighten the
screw with the hex key. Do not over tighten!
19