Settings Page Definitions - Grandstream Networks GXP1610 Administration Manual

Call Recording On
Call Recording Off
Hide Dialing
Password
Remote Info Display
Hide Remote User ID
Account x  Feature Codes
Call Forward
Unconditionally (All)
Call Forward Busy
Call Forward Delayed
(No Answer)

Settings Page Definitions

Settings  General Settings
Local RTP Port
Use Random Port
Keep-alive Interval
Use NAT IP
Configures the DTMF sequence sent when pressing the Record key during a
call on this account.
Configures the DTMF sequence sent when pressing the Record key during a
call on this account when turning recording off.
Allows user to hide the password when the dialing number matches the
configured prefix.
Choose which caller information to display once receiving a call:
•
Name and Number: Display the caller ID name and number.
•
Number: Display only the caller number.
•
Name: Display only the caller ID name.
Settings to allow user to hide and display name of remote user ID that has a
length more than specific in the incoming and/or outgoing calls
Unconditional call forwarding will forward all calls from the activated account to
the target phone.
Buzzy call forwarding will only forward a call from the activated account to
the target phone when it's busy.
Delayed call forwarding allows to forward incoming calls from the activated
account to target when there is no response after a specified length of time.
Table 9: Settings Page Definitions
Defines the local RTP port used to listen and transmit. It is the base RTP port
for channel 0. When configured, channel 0 will use this port _value for RTP;
channel 1 will use port_value+2 for RTP. Local RTP port ranges from 1024 to
65400 and must be even. The default value is 5004.
When set to "Yes", this parameter will force random generation of both the local
SIP and RTP ports. This is usually necessary when multiple phones are behind
the same full cone NAT. The default setting is "Yes" (This parameter must be
set to "No" for Direct IP Calling to work).
Specifies how often the phone sends a blank UDP packet to the SIP server in
order to keep the "ping hole" on the NAT router to open. The default setting is
20 seconds.
The NAT IP address used in SIP/SDP messages. This field is blank at the
default settings. It should ONLY be used if it's required by your ITSP.
GXP16XX Administration Guide
Version 1.0.4.100
P a g e | 38