Fujitsu Arrows NX F-01J Instruction Manual page 181

● The clock is not on time
When the terminal is turned ON for a long time, the clock
may go wrong. Check if [Automatic date & time]/
[Automatic time zone] in Date & time is marked and
restart the terminal in a place where the reception
condition is good.→P155
● Terminal operation is unstable
•
Instability may be caused by application that you
installed after purchasing the terminal. If the symptom
is improved when you boot the terminal in safe mode
(function for booting in near default state), uninstalling
the installed application may improve the symptom.
Boot the terminal in safe mode by one of the following
procedure.
- Press and hold P until the tablet options menu
appears→Touch and hold [Restart]→[OK]
- With the power turned off, press and hold P for 2
seconds or more. Immediately after the docomo logo
disappears, press and hold the volume down key
When safe mode is booted, "Safe mode" is displayed at
the lower left of the screen. To exit the safe mode, turn
the power OFF and ON.
* Back up the necessary data before using safe mode.
* Safe mode is not a normal booting state. To use ordinarily, exit the
safe mode.
* Some widgets may be removed.
● Operations are not possible when tapping the screen
•
Do you operate with a fingernail or foreign object on the
screen?
•
Do you put a protective sheet or sticker on the display?
Depending on the protective sheet, you cannot operate
the terminal correctly.
•
Do you operate with the touch panel wet or with your
finger wet with sweat or water?
•
Do you operate under water?
•
Touch the touch panel with your finger directly to
operate the terminal.
● Operations are slower/Application operation is
unstable/Some applications are not activated
Operation becomes unstable if the terminal is low on
memory. When a message indicating the memory space
is short is displayed, delete unnecessary applications.→
P88, P152
● Applications cannot be operated properly (applications
cannot be activated/errors occur frequently)
Are there any applications being disabled? Enable
disabled applications, then retry to operate.→P152
● Data is not displayed normally/Normal touch panel
operations are not possible
Turn the terminal OFF and ON.→P36
● The screen does not turn on when Touch and go display
is set
Is the touch time on the screen too short?→P124
■ Phone/Voice call
● Cannot dial by tapping
Do you set Airplane mode?→P134
● During a voice call, the distant party's voice is hard to
listen to or too loud
Adjust the listening volume. Turn on Voice clear and Voice
slowing to make the other party's voice easy to
understand.→P67
179
Appendix/Index