Fujitsu Arrows NX F-01J Instruction Manual page 133

◆ Stopping packet connection
Some applications automatically perform packet
communications. Packet communication is kept active unless
you cut off the connection or the time-out occurs. Activate or
deactivate packet communication as required.
1
From the Home screen,
communication/Airplane mode]→[Cellular
networks]
2
Turn OFF [Data enabled]
3
Check the content and [OK]
◆ Setting access point (APN)
Access point for connecting to the Internet (sp-mode) is
already registered. You can add and change access points if
necessary.
For details on sp-mode, refer to NTT DOCOMO website.
https://www.nttdocomo.co.jp/service/spmode/
For using mopera U, Business mopera Internet, add the access
point manually.
For details on mopera U, refer to mopera U website.
https://www.mopera.net/
･
When Tethering is set to on, access point setting is
unavailable.→P133
❖
Checking the access point in use
1
From the Home screen,
communication/Airplane mode]→[Cellular
networks]→[Access Point Names]
→[Settings]→[Data
→[Settings]→[Data
131
❖
Adding an access point
･
Do not change the MCC/MNC to other than 440/10. The
setting disappears from the screen.
1
From the Home screen,
communication/Airplane mode]→[Cellular
networks]→[Access Point Names]
2
[＋]
3
[Name]→Enter a network profile→[OK]
4
[APN]→Enter the access point name→[OK]
5
Enter other items required by network
operator→[MENU]→[Save]
✔INFORMATION
･
When MCC and MNC settings are not displayed on the screen
after being changed, reset it to the default settings or set the
access point manually.
❖
Initializing an access point
By initializing an access point, the default state is restored.
1
From the Home screen,
communication/Airplane mode]→[Cellular
networks]→[Access Point Names]
2
[MENU]→[Reset to default]
→[Settings]→[Data
→[Settings]→[Data
Settings