Troubleshooting - Pyle PLCD79MP Instruction Manual

DSP
In DSP mode you can select the equalizer settings POP M, JAZZ M,
CLASS M and FLAT M, and DSP OFF by rotating the VOL +/- knob.
BEEP ON/OFF
You can select two types of confirmation beep by rotating the VOL +/-
knob.
BEEP ON: The confirmation beep can be heard whenever a button is
pressed.
BEEP OFF: The confirmation beep is switch off.
SEEK 1/ 2 (only available during radio operation)
Seek function with the or
You can select SEEK 1/ SEEK 2 by rotating the VOL +/- knob.
SEEK 1: Keep the or buttons pressed down and the radio will
stop at the next station that is detected.
SEEK 2: As long as the or
function will continue in the frequency band.
VOL LAST/VOL ADJ
You can select VOL LAST or VOL ADJ mode by rotating the VOL +/- knob.
VOL LAST: The radio switches on at the actual volume it had when
it was last switched off.
VOL Addition: Rotating the VOL +/- knob you can pre-select a constant
switch-on volume.
4. POWER ON/OFF
Turn the power on by using any button except the OPEN and REL button
and the VOL +/- knob on the front control panel; Press PWR button and
hold for approximate two seconds to turn power off.
Press the PWR button repeatedly to adjust the brightness of the VFD.
5. VFD Display
6.7. TUNE, SEEK, TRACK, SKIP UP / DOWN BUTTONS
a) During RADIO mode:
press the or button briefly to tune a frequency manually.
Press the or button and hold for more than one second to start
the automatic search for a radio station with a strong signal level.
(See also the function SEEK 1/SEEK 2.)
b) During CD/MP3 mode:
press the button briefly to play next track. Press the
briefly to play the current track from the beginning of the current track.
Press the button twice continuously to play the previous track.
Press the or button hold to skip forward or backward.
8. BAND BUTTON
Press the BND button briefly to select the radio broadcasting band you
would hear.
buttons during radio operation.
buttons are pressed down the search
button
3
TROUBLE SHOOTING
Before using the check list please make all the connections first.
If you still have questions after going through the checklist, please consult
your local customer service representative.
Common Symptoms
Cause
The car ignition is switched off.
There is no power.
The fuse has blown.
The CDs cannot Presence of CD disc inside the player
be loaded.
The CDs are loaded The transport screws have not been
only halfway into removed.
the CD tray.
Inserting the disc in upside down
The device does
The surface of CD is extremely dirty
not work correctly
or it is damaged.
(EJECT, LOAD,
PLAY)
Temperature inside the car is too
high.
The volume control is set too low.
There is no sound.
The device has not been correctly
connected.
The operation keys 1.The built-in microcomputer is not
do not work operating properly due to noise
2.Front panel is not properly fix into
its place
The installation angle is more than
30 degrees
The surface of the road is uneven.
The sound of the
CD player skips
The surface of CD is extremely dirty
or it is damaged.
No radio reception. The antenna cable is not connected.
In automatic search The transmission signals are too
mode the radio does weak.
not stop at a trans-
mitting station.
Solution
If the power supply is properly connected to
the car accessory, switch the ignition key to
" ON " or " ACC " .
Replace another fuse according to the wiring
diagram.
Remove the disc in the player then put a new
upward
Remove the transport screws before using.
Insert the compact disc with the label facing
upward
Clean the CD or try another CD, if this works
correctly, the first CD is properly damaged.
Cool off until the ambient temperature returns
to normal
Turn up the volume properly.
Check the power and earth connection
according to the wiring diagram.
1. Switch the device off and on again. Or press
the RESET button to resume the program.
2. Reinstall the front panel
Adjust the installation angle to less than 30
degrees
Wait until the road becomes smoother before
playing the CD.
Clean the CD or try another CD, if this works
correctly, the first CD is properly damaged.
Insert the antenna cable firmly into the
antenna socket of the device.
Tune in to a radio station manually.
12