BEA IXIO-DT1 Manual page 6

OVERVIEW OF SETTINGS
Back
More
RAD: FIELDSIZE
AIR: WIDTH
+
AIR: OUTPUT
TEST
More
Back
Back
More
RAD: FIELDSIZE
RAD: IMMUNITY
RAD: DIRECTION
RAD: HOLDTIME
RAD: REENTRY
RAD: OUTPUT
AIR: IMMUNITY
AIR: WIDTH
+
AIR: NUMBER
AIR: PRESENCE TIME
AIR: FREQ
AIR: OUTPUT
TEST
REDIRECTION
motion
FACTORY RESET
More
Back
ZIP CODE all parameter settings in zipped format
(see application note on ZIP CODE – 76.0024)
ID # unique ID-number
CONFIG P/N
SOFT P/N
ERROR LOG last 10 errors + day indication
AIR: SPOTVIEW view of spot(s) that trigger detection
Page 6 of 9
0 1 2 3
small > > >
DeEner/NO Energ/NC Energ/NC
Energ/NC DeEner/NO Energ/NC
off on
Monitoring functionality must be active on the sensor and monitoring wires must be properly connected to the door control.
small > > >
low > >
uni
off bi uni
MTF
0.5 s 1 s 2 s 3 s
small > > >
DeEner/NO Energ/NC
Energ/NC
Energ/NC DeEner/NO
Energ/NC
normal
enhanced
1 2
30 s 1 min
A B
DeEner/NO Energ/NC Energ/NC
Energ/NC DeEner/NO
Energ/NC
off on
Monitoring functionality must be active on the sensor and monitoring wires must be properly connected to the door control.
motion
or
presence
factory value
4 5 6 7
> > > >
DeEner/NO
DeEner/NO
The sensor LED will briefly flash RED during monitoring communication with door control.
> > > >
> > > >
4 s 5 s 6 s 7 s
> > > >
DeEner/NO
DeEner/NO
mode B
2 min 5 min 10 min 20 min
DeEner/NO
DeEner/NO
The sensor LED will briefly flash RED during monitoring communication with door control.
AIR: C1 ENERG
AIR: C2 ENERG
POWERSUPPLY
OPERATINGTIME
RESET LOG
PASSWORD
ADMIN
8 9
> large
Always additionally adjust the
arrow position on the sensor with a
DeEner: De-Energized relay
Energ: Energized relay
NC: normally closed
This indicates that external monitoring is functional.
> large
> high
MTF: motion tracking feature
8 s 9 s
> large
DeEner: De-Energized relay
Energ: Energized relay
NC: normally closed
Always additionally adjust the
arrow position on the sensor with a
min. value for DIN18650: 1 min
60 min infinte
min. value for EN16005: 30 s
DeEner: De-Energized relay
Energ: Energized relay
NC: normally closed
This indicates that external monitoring is functional.
opening output is active in case of:
0 motion detection
1 motion or presence detection
2 motion and presence detection
full partial
partial: outputs are not reset
reset reset
signal amplitude received on curtain 1
signal amplitude received on curtain 2
supply voltage at power connector
power duration since first startup
delete all saved errors
LCD and remote control password
(0000= no password)
enter code to access admin mode
75.5751.11 IXIO-DT1 UL 20180305
screwdriver.
NO: normally open
NO: normally open
screwdriver.
NO: normally open