Reference Information; Mounting The Switcher; Tabletop Use; Mounting Kits - Extron electronics DTP T USW 233 User Manual

Reference
Information
This section provides procedures for mounting the DTP T USW 233 switching transmitter
and disconnecting the ground between it and a compatible receiver.
•
•

Mounting the Switcher

ATTENTION:
The 1-inch high, half rack width DTP T USW 233 switching transmitter can be placed on a
table, mounted in a rack, or mounted under a desk or table.

Tabletop Use

Affix the included rubber feet to the bottom of the unit and place it in any convenient
location.

Mounting kits

Mount the unit using any optional compatible mounting kit listed on the Extron website
(www.extron.com), in accordance with the directions included with the kit. For rack
mounting, see
Mounting the Switcher
Disconnecting the Ground
• Installation and service must be performed by authorized personnel only.
Avoid ground potential differences between the switching transmitter and receiver
installation sites, which can lead to equipment damage or a missing or unstable
picture. If a potential difference cannot be avoided, remove the ground connection
between the units and locally power both units (see
on page 32).
• L'installation et l'entretien doivent être effectués par le personnel autorisé
uniquement.
Évitez les différences de potentiel de mise à la terre entre les sites d'installation
de commutation émetteur récepteur, qui pourraient endommager l'équipement
ou rendre l'image invisible ou instable. Si une différence de potentiel ne peut être
évitée, enlevez la connexion de mise à la terre entre les unités et alimentez les deux
unités localement (voir Disconnecting the Ground
UL Rack-Mounting Guidelines
Disconnecting the Ground
à la terre page 32). .
on the next page.
DTP T USW 233 • Reference Information 31