Table of Contents
Advertisement
2. Remove the rear drive level plug; lubricant should be
visible at the plug threads. If low, add SAE approved
80W-90 hypoid lubricant to the fill plug as necessary.
Install the plug and tighten to 22 N-m (16 ft-lb).
CAUTION
Any lubricant used in place of the recommended
lubricant could cause serious rear drive damage.
CHECKING/ADJUSTING
HEADLIGHT AIM
The headlights can be adjusted vertically. The center of
the HIGH beam light zone is to be used for aiming.
1. Position the vehicle on a level floor so the head-
lights are approximately 6.1 m (20 ft) from an aim-
ing surface (wall or similar aiming surface).
NOTE: There should be an average operating load
on the vehicle when adjusting the headlight aim.
2. Measure the distance from the floor to the mid-
point of each headlight.
3. Using the measurements obtained in step 2, make
horizontal marks on the aiming surface.
4. Make vertical marks which intersect the horizontal
marks on the aiming surface directly in front of the
headlights.
5. Switch on the lights. Make sure the HIGH beam is
on. DO NOT USE LOW BEAM.
6. Observe each headlight beam aim. Proper aim is
when the HIGH beam is centered on the vertical
HDX083A
mark 5 cm (2 in.) below the horizontal mark on the
aiming surface.
7. Turn the adjuster nut clockwise to raise the beam
and counterclockwise to lower the beam.
RECOMMENDED GASOLINE
The recommended gasoline to use is 87 minimum octane
regular unleaded. In many areas, oxygenates are added to
HDX084A
the gasoline. Oxygenated gasolines containing up to 10%
ethanol or 5% methane are acceptable gasolines.
When using ethanol blended gasoline, it is not necessary
to add a gasoline antifreeze since ethanol will prevent
the accumulation of moisture in the system.
Do not use white gas. Only Toro approved gasoline
and/or additives should be used.
TEST DRIVING
1. Check all mechanical functions.
2. Burnish the brake pads (see Burnishing Brake Pads).
3. Confirm all cables and wiring harnesses are con-
nected and routed correctly.
4. Confirm all lights work correctly: headlights (HI-
LO), taillight/brakelight, gauge, dash.
5. Confirm cooling fan operates normally.
6. After the test drive, check the brake systems.
7. Inspect the owner's packet to ensure it is complete
0740-647
(Operator's Manual, spanner wrench).
8. Visually inspect the entire vehicle for any loose fasten-
ers. Tighten as required to the appropriate specifications.
CAUTION
TC004A
9
Advertisement
Table of Contents
