Table of Contents
Advertisement
7. Install the seat belts (cap screws installed from the
front) into the appropriate mounting tabs along the
headrest support tube on the rear ROPS. Tighten to
47 N-m (35 ft-lb).
8. Place Right-Side Occupant Side Restraint onto the
passenger-side tube and secure using four Cap
Screws. Tighten to 13.5 N-m (10 ft-lb).
9. Secure the outer side restraint using two Cap
Screws making sure to keep the straps properly
positioned.
10. Route the lower side restraint straps inside the side
tube; then secure to the frame using two Shoulder
Screws and Flange Nuts. Tighten to 13.5 N-m (10
ft-lb).
TC027
11. Loop the rear anchor strap around the ROPS mount-
ing tube and secure with the buckle. Tighten so
strap rests as shown.
TC029
12. Repeat steps 9-11 for opposite side.
13. Secure both side restraints to the kick panels using
the buckle.
CHECKING COOLING SYSTEM
PR835A
Remove the filler cap and check coolant level. Coolant
level should be at the bottom of the standpipe in the
radiator neck. If coolant is required, add to bring coolant
to the specified level and install the cap.
NOTE: If coolant is required, mix coolant for a
temperature of -36°C (-34°F). Follow mixing recom-
mendations of the manufacturer.
It is extremely important that the cooling system is
properly filled. If the system isn't properly filled,
engine damage will occur.
CAUTION
PR834A
PR831A
PR833
5
Advertisement
Table of Contents
