Xconfiguration Network [1] Ieee8021X Mode; Xconfiguration Network [1] Ieee8021X Tlsverify; Xconfiguration Network [1] Ieee8021X Useclientcertificate; Xconfiguration Network [1] Ieee8021X Identity - Cisco MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

xConfiguration Network [1] IEEE8021X Mode

The system can be connected to an IEEE 802.1X LAN network, with a port-based network
access control that is used to provide authenticated network access for Ethernet networks.
Requires user role: ADMIN, USER
Default value: Off
USAGE:
xConfiguration Network n IEEE8021X Mode:
where
n
: Index that identifies the network. Range: 1..1
Mode
: Off/On
Off: The 802.1X authentication is disabled (default).
On: The 802.1X authentication is enabled.

xConfiguration Network [1] IEEE8021X TlsVerify

Verification of the server-side certificate of an IEEE802.1x connection against the certificates in
the local CA-list when TLS is used. The CA-list must be uploaded to the video system. This can
be done from the web interface.
This setting takes effect only when Network [1] IEEE8021X Eap Tls is enabled (On).
Requires user role: ADMIN, USER
Default value: Off
USAGE:
xConfiguration Network IEEE8021X TlsVerify:
n
where
n
: Index that identifies the network. Range: 1..1
TlsVerify
: Off/On
Off: When set to Off, TLS connections are allowed without verifying the server-side
X.509 certificate against the local CA-list. This should typically be selected if no CA-list
has been uploaded to the codec.
On: When set to On, the server-side X.509 certificate will be validated against the local
CA-list for all TLS connections. Only servers with a valid certificate will be allowed.
D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xConfiguration
Mode
TlsVerify
xCommand

xConfiguration Network [1] IEEE8021X UseClientCertificate

Authentication using a private key/certificate pair during an IEEE802.1x connection. The authen-
tication X.509 certificate must be uploaded to the video system. This can be done from the
web interface.
Requires user role: ADMIN, USER
Default value: Off
USAGE:
xConfiguration Network n IEEE8021X UseClientCertificate:
where
n
: Index that identifies the network. Range: 1..1
UseClientCertificate
: Off/On
Off: When set to Off client-side authentication is not used (only server-side).
On: When set to On the client (video system) will perform a mutual authentication TLS
handshake with the server.

xConfiguration Network [1] IEEE8021X Identity

Define the user name for 802.1X authentication.
Requires user role: ADMIN, USER
Default value: ""
USAGE:
xConfiguration Network n IEEE8021X Identity: "Identity"
where
n
: Index that identifies the network. Range: 1..1
Identity
: String (0, 64)
The user name for 802.1X authentication.
65
API Reference Guide
xStatus Appendices
UseClientCertificate
Copyright © 2017 Cisco Systems, Inc. All rights reserved.