Viewing Default Values - Cisco RV215W Administration Manual

Configuring VPN
Configuring Basic VPN Settings (Site-to-Site VPN)
STEP 6
STEP 1
STEP 2
Cisco RV215W Wireless-N VPN Firewall Administration Guide
Draft Version 1—Cisco Confidential
Note: The remote WAN and remote LAN IP addresses cannot exist on the same
subnet. For example, a remote LAN IP address of 192. 1 68. 1 . 1 00 and a local LAN
IP address of 192. 1 68. 1 . 1 15 would cause conflict when traffic is routed over the
VPN. The third octet must be different so that the IP addresses are on different
subnets. For example, a remote LAN IP address of 192. 1 68. 1 . 1 00 and a local LAN
IP address of 192. 1 68.2. 1 00 is acceptable.
Click Save.

Viewing Default Values

The default values used in the basic VPN settings are those proposed by the VPN
consortium and they assume you are using a pre-shared key, or password, that is
known to both the and the router on the other end (for example, a Cisco RV220W).
To view the default values:
Choose VPN > Basic VPN Setup.
Click View Default Settings to view the default values.
For more information on these values, see
Parameters.
Configuring Advanced VPN
5
92