Report Settings; Basic Settings - Epson WorkForce Pro WF-4720 series User Manual

User's Guide

Report Settings

Select the menu on the control panel as described below.
Settings > General Settings > Fax Settings > Report Settings
Fax Log Auto Print:
Prints the fax log automatically. Select On(Every 30) to print a log every time 30 fax jobs are
completed. Select On(Time) to print the log at a specified time. However, if the number of fax jobs
exceeds 30, the log is printed before the specified time.
Attach Fax image to report:
Prints a Transmission Report with an image of the first page of the sent document. Select On(Large
Image) to print the upper part of the page without reducing. Select On(Small Image) to print the
entire page reducing it to fit onto the report.
Report Format:
Select a format for fax reports. Select Detail to print with error codes.

Basic Settings

Select the menus on the control panel as described below.
Settings > General Settings > Fax Settings > Basic Settings
Fax Speed:
Select the fax transmission speed. We recommend selecting Slow(9,600bps) when a communication
error occurs frequently, when sending/receiving a fax to/from abroad, or when you are using an IP
(VoIP) phone service.
ECM:
Automatically corrects errors in the fax transmission (Error Correction Mode), mostly caused by
telephone line noise. If this is disabled, you cannot send or receive documents in color.
Dial Tone Detection:
Detects a dial tone before starting to dial. If the printer is connected to a PBX (Private Branch
Exchange) or digital phone line, the printer may fail to start dialing. In this situation, change the Line
Type setting to PBX. If this does not work, disable this feature. However, disabling this feature may
drop the first digit of a fax number and send the fax to the wrong number.
Line Type:
Select the line type to which you have connected the printer. When using the printer in an environment
that uses extensions and requires an external access code, such as 0 and 9, to get an outside line, select
PBX and register the access code. Once you have registered the access code, enter # (hash) instead of
the access code when sending a fax to an outside fax number. For an environment that uses a DSL
modem or terminal adapter, setting to PBX is also recommended.
Header:
Enter your sender name and fax number. These appear as a header on outgoing faxes. You can enter up
to 40 characters for your name, and up to 20 digits for your fax number.
Faxing
133