Tilt Sensor Removal - JLG 1930ES Service Maintenance Manual

2 1
1. Tilt Sensor (JLG P/N 4000006)
2. Screw, 3.5 x 0.6 x 16 LG
Figure 3-44. Tilt Sensor Removal
Table 3-6. Tilt Sensor Harness Chart
Wire Color Function
Red VCC
Black Ground
Blue PWMX
Yellow PWMY
3121166
Tilt Sensor, JLG P/N 4000021 and 1001114936:

Tilt Sensor Removal:

NOTE: Refer to Figure 3-46., Tilt Sensor Removal for num-
1. Disconnect the batteries.
Connector Pin
1
2. Open the Ground Control Station to gain access to
4
2
3. Remove the four Screws (3), to remove the Tilt Sen-
3
4. The Tilt Sensor (1) can be removed from the Sensor
NOTE: Follow the above procedures in reverse order when
– JLG Lift –
SECTION 3 - CHASSIS & SCISSOR ARMS
2
1
1. Ground Control Station
2. Tilt Sensor (JLG P/N 4000021 or
1001114936)
Figure 3-45. Tilt Sensor Location
bers in parenthesis.
the Tilt Sensor Assembly. (refer to prior mentioned
procedures)
sor (1) and Sensor Mount (2) from the Ground Con-
trol Box.
Mount (2) by removing the three Screws (4).
installing the tilt sensor assembly. After installing, be
sure to calibrate the tilt sensor (refer to Section 5.2,
Tilt Sensor Calibration).
3-61