10. Push contact straight into connector grommet until a positive stop is felt. A slight tug will confirm that it is properly
locked in place.
NOTE: For unused wire cavities, insert sealing plugs for full environmental sealing
HD30/HDP20 Series Disassembly
11. With rear insert toward you, snap appropriate size extractor tool over the wire of contact to be removed.
12. Slide tool along into the insert cavity until it engages contact and resistance is felt.
13. Pull contact-wire assembly out of connector.
NOTE: Do Not twist or insert tool at an angle.
3121166
SECTION 7 - GENERAL ELECTRICAL INFORMATION & SCHEMATICS
Figure 7-15. HD/HDP Locking Contacts Into Position
Figure 7-16. HD/HDP Contact Removal
Figure 7-17. HD/HDP Unlocking Contacts
– JLG Lift –
7-11