Battery Removal - JLG 1930ES Service Maintenance Manual

SECTION 3 - CHASSIS & SCISSOR ARMS

3.10 BATTERY REMOVAL

NOTICE
JLG MACHINES EQUIPPED WITH DELTA Q BATTERY CHARGERS
ARE DESIGNED FOR THE BEST PERFORMANCE WITH OEM FAC-
TORY APPROVED BATTERIES.
APPROVED JLG REPLACEMENT BATTERIES ARE AVAILABLE
THROUGH JLG' S AFTERMARKET PARTS DISTRIBUTION CEN-
TERS OR JLG' S AFTERMARKET PROGRAMS. FOR ASSISTANCE
WITH PROPER BATTERY REPLACEMENT, PLEASE CONTACT
YOUR LOCAL JLG SUPPORT OFFICE.
BATTERIES APPROVED BY JLG HAVE BEEN TESTED FOR COM-
PATIBILITY WITH THE ALGORITHM PROGRAMMING OF THE
DELTA Q BATTERY CHARGER TO OPTIMIZE BATTERY LIFE AND
MACHINE CYCLE TIMES. THE USE OF NON APPROVED BATTER-
IES IN YOUR JLG EQUIPMENT MAY RESULT IN PERFORMANCE
ISSUES OR BATTERY CHARGER FAULT CODES. JLG ASSUMES
NO RESPONSIBILITY FOR SERVICE OR PERFORMANCE ISSUES
ARISING FROM THE USE OF NON APPROVED BATTERIES.
BEFORE BATTERY REMOVAL CAN BEGIN, ENSURE THAT THE
BATTERIES HAVE BEEN PROPERLY DISCONNECTED TO AVOID
SERIOUS INJURY OR POSSIBLE DEATH.
1. Pull the battery door completely out and disconnect
the batteries.
2. Rest the battery door onto the forks of a fork truck,
or suitable lifting device. Be sure the forks or lifting
device are properly centered over the weight of the
battery door.
3. Using a phillips screwdriver, remove the battery door
rollers located at the rear corners of the battery door.
3-42
4. Adjust the lifting device to take the weight of the bat-
tery door and remove door from under the machine.
5. Once the battery door is removed from the machine,
battery replacement/maintenance can begin.
6. After any maintenance on the batteries or replace-
ment of the batteries is complete lift the battery door
back onto the machine.
7. Make sure the rollers are replaced and tight.
8. Reconnect batteries and check for proper operation.
– JLG Lift – 3121166