Table of Contents
Advertisement
INSTALLATION
Notes:
Choose the mounting location where
the unit will not interfere with the
normal driving function of the driver.
Before finally installing the unit,
connect the wiring temporarily and
make sure it is all connected up
properly and the unit and the system
work properly.
Use only the parts included with the
unit to ensure proper installation. The
use of unauthorized parts can cause
Malfunctions.
Consult with your nearest dealer if
installation requires the drilling of
holes or other modifications of the
Vehicle.
Install the unit where it does not get
in the driver's way and cannot injure
the passenger if there is a sudden
stop,like an emergency stop.
If installation angle exceeds 30 from
horizontal, the unit might not give its
optimum performance.
30
Avoid installing the unit where it would
be subject to high temperature, such
as from direct sunlight, or from hot air,
from the heater, or where it would be
subject to dust, dirt or excessive
vibration.
DIN FRONT/REAR-MOUNT
This unit be can properly installed either
from "Front"(conventional DIN
Front-mount) or "Rear"(DIN Rear-mount
installation, utilizing threaded screw holes
at the sides of the unit chassis). For
details, refer to the following illustrated
installation methods.
TAKE OUT SCREW BEFORE
INSTALLATION
Before install the unit, please remove
the two screws on the back of the unit.
Take out screw
before installation.
DIN FRONT-MOUNT (Method A)
Installation Opening
This unit can be installed in any
dashboard having an opening as show
below:
O
182mm
Installing the unit
Be sure you test all connections first, and
then follow these steps to install the unit.
1.
Make sure the ignition is turned off,
and then disconnect the cable from the
vehicle battery's negative (-) terminal.
2.
Disconnect the wire harness and the
Antenna.
3.
Lift the top of the outer trim ring then
pull it out to remove it.
4.
The two supplied keys release tabs
inside the unit's sleeve so you can
remove it. One key is for the right side
and the other is for the left side. Insert
the keys as far as they will go (with the
notches facing up) into the appropriate
slots at the middle left and right sides
of the unit. Then slide the sleeve off
the back of the unit.
4
53mm
Advertisement
Table of Contents
