6.5 Inch Tft Display; Reset Function; Tv Operation; Selecting Receiving Mode - Pyle PLTV165 Owner's Manual

OPERATION
Notes:
The external remote receiver is placed
near the monitor for the best to receiver
remote signal easily.
If the angle of the monitor from vertical
0
exceeds 20 (Especially the distance
exceeds 3m.), controlling the TV
through IR (3) or (13) cannot get good
effect. You are suggested to use the
external remote receiver.

6.5 inch TFT DISPLAY

When the monitor stretches out, the 6.5
inch color TFT display (6) can show the
current state of the unit.

RESET FUNCTION

Reset button (7) must be activated with
either a ballpoint pen or thin metal object.
The reset button is to be activated for the
following reasons:
Initial installation of the unit when all
wiring is completed.
All the function buttons do not
operate.
Error symbol on the display.
Note: When the monitor stretches out and
on the central viewing position, activate
the reset button (7), the monitor will turn
downward and draw in automatically.

TV OPERATION

When the monitor stretches out, you can
operate the unit by using the current
menu displayed on the 6.5 inch color TFT
display (6).

Selecting receiving mode

In TV mode, press TV/AV button (11)
on the monitor panel or TV/AV button
(19) on the remote control to select
among TV/ AV1/AV2/RGB. The
corresponding state will show on the
TFT display (5).

Selecting channel

Press CHANNEL
on the front panel or CHANNEL
(26) button on remote control to
choose channel upward and or

Menu Function

Press MENU button (10) on the front
panel or MENU button (30) on the
remote control, the menu will show
on the display (6).
(For the unit with NTSC system):
Press CHANNEL /
the front panel or CHANNEL /
buttons (26&27) on the remote
control to select the item upward or
downward. Then press VOLUME /
(8&9) on the front panel or
VOLUME / buttons (24&25) on
the remote control to adjust the
selected item. The corresponding
value will show on the display.
button (14)
^
11
Press CHANNEL button (15) or
CHANNEL (27) button on
remote control to choose channel
downward.
The numeric buttons (0,1~9) (20)
allow you to select the
corresponding channel directly.
Press digital select button (-/--) ()
cooperatively used with numeric
buttons to select channel desired.
For example, when you want select
16 channel, press -/-- (28) to switch
between "-" and "--", when the "--"
appears on the display, you can
press "1" button then press "6"
button to select 16 channel.
MENU
(14&15) on
^
^
^
^