Configuring Static Ports - HP FlexFabric 5700 Series Configuration Manual

Step
4. Set the aging timer for
dynamic member ports
globally.
Setting the aging timers for the dynamic ports in a VLAN
Step
1. Enter system view.
2. Enter VLAN view.
3. Set the aging timer for the
dynamic router ports in
the VLAN.
4. Set the aging timer for the
dynamic member ports in
the VLAN.

Configuring static ports

You can configure the following types of static ports:
Static member port—When you configure a port as a static member port for an IPv6 multicast
•
group, all hosts attached to the port will receive IPv6 multicast data for the group.
The static member port does not respond to MLD queries. When you configure or cancel this
configuration, the port does not send an unsolicited report or done message.
Static router port—When you configure a port as a static router port for an IPv6 multicast group, all
•
IPv6 multicast data for the group received on the port will be forwarded.
Static member ports and static router ports never age out. To remove such a port, use the undo
mld-snooping static-group or undo mld-snooping static-router-port command.
To configure static ports:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
3. Configure the port as a static
port.
Command
host-aging-time interval
Command
system-view
vlan vlan-id
mld-snooping router-aging-time
interval
mld-snooping host-aging-time
interval
Command
system-view
interface interface-type
interface-number
•
Configure the port as a static
member port:
mld-snooping static-group
ipv6-group-address [ source-ip
ipv6-source-address ] vlan
vlan-id
•
Configure the port as a static
router port:
mld-snooping
static-router-port vlan vlan-id
67
Remarks
The default setting is 260 seconds.
Remarks
N/A
N/A
The default setting is 260 seconds.
The default setting is 260 seconds.
Remarks
N/A
N/A
By default, a port is not a static
member port or a static router port.