ZyXEL Communications ALC1224 User Manual page 126

ALC1224 User's Guide
[llc|vc|vcprofile=<vcprofile>]
[priority=<pri>]
The pvc set command allows the configuration of a PVC (permanent virtual circuit) for one or a range of
ADSL ports. Two examples are shown next.
ras> lcman port pvc set 3-1-0/34 super
ras> lcman port pvc set 3-1-0/35 vid=100 priority=1 llc
12.3.2 PVC Show Command
Syntax:
lcman port pvc show
The pvc show command allows you to display the PVC parameters of one or a range of ADSL ports.
12.3.3 Delete PVC Command
Syntax:
lcman port pvc delete <slot-port-vpi/vci>
where
<slot-port-vpi/vci>
The command deletes the specified PVC channel.
pvc delete
12-4
= Define the multiplexing mode or assign a virtual channel profile
to the PVC.
= This is the priority value (0 to 7) to add to incoming frames
without a (IEEE 802.1p) priority tag. You cannot configure a
priority for a super channel.
=
The slot, port, VPI and VCI numbers. The VPI setting can be 0 to 255. The
VCI setting can be 32 to 65535 if the vpi is 0 or 1 to 65535 if the vpi is not 0.
You can use ranges. Here are some examples:
<*-*-0/33 > would configure all of the Integrated Ethernet Switch's DSL
ports to use a VPI of 0 and a VCI of 33.
<1-*-0/33> would configure all of the DSL ports on the line card in slot 1 to
use a VPI of 0 and a VCI of 33.
<3-1,3~5,10~15-0/33> would configure DSL ports 1, 3-5 and 10-15 on the
line card in slot 1 to use a VPI of 0 and a VCI of 33.
Virtual Channel Management