Lubrication Guide- Standard - Sullair LS-100L Operator's Manual

Section 3
SPECIFICATIONS
LS-100 SERIES (CONTINUED)
ENCL HP/KW
(ACFM/M 3 /MIN)
MODEL
25-30 HP/ -
18-22 KW -
40 HP/
30 KW -
(I) For water-cooled (open) model, add 1.5 in/ 38mm to length, and 1 in/ 25 mm to height.
(II) An additional length of 4 in./102mm is needed for servicing the separator; 9 in./229mm for enclosure models.
(III) Add 250 lbs/ 113.4 kgs for the enclosure to the total package weight.
COMPRESSOR:
Type:
Standard Operating Pressure (IV):
Bearing Type:
Ambient Temperature (Max.) (V):
Cooling:
Compressor Fluid:
Sump Capacity:
Control:
MOTOR (VI):
Size:
Type:
Starter:
Speed:
(IV) Special compressors are available for operation at higher pressures.
(V) Special compressors are available for operation in higher ambient temperature.
(VI) Multi-frequency and voltage motors are used. The compressors must be used only with the specified
electrical frequency and voltage.

3.2 LUBRICATION GUIDE- STANDARD

Refer to Figure 3-1
best value and longest uninterrupted service, the
LS-100 Series compressors are factory filled and
tested with Sullube lubricant.
16
CAPACITY LENGTH (I)
(IN/MM)
- 60.0/1524
- 66.0/1676.4
- 66.0/1676.4
for location of fluid fill port. For
WIDTH HEIGHT(II)
(IN/MM)
36.0/914 42.0/1067
36.0/914 42.0/1067
36.0/914 42.0/1067
STANDARD MODELS
Rotary Screw
100 psig (6.9 bar) (L)
125 psig (8.6 bar) (H) (XH)
Anti-Friction
105ºF (41ºC)
Pressurized Fluid
Sullair Sullube
3.0 U.S. gallons (11.4 liters)
Electro-Pneumatic
Supervisor II (optional)
STANDARD MODELS
25, 30 and 40HP
C-Flanged, Open Dripproof, Premium Efficiency
Three Phase, 230/460 60 Hz, 380/415 50 Hz
40ºC Maximum Ambient Temperature
Options Available: 200V and 575V
T.E.F.C. Also Available: IP54
Full Voltage Magnetic or Wye Delta
Options Available: 200V and 575V
60 Hz: 1770 RPM
50 Hz: 1475 RPM (except 40L, 40H and 40HH = 2950 RPM)
40L, 40H, 40HH, 40XH: 1475RPM
Mixing of other lubricants within the compressor
unit will void all warranties
If, due to availability or other reasons, other fluids
are required, follow Lubrication Guide 3.4 below.
WEIGHT
(IN/MM) (LB/KG)
(III)
(III)
(III)
150 psig (10.3 bar) (HH)
175 psig (12 bar) (XH)
MOTOR
ENCLOSURE
ODP
TEFC
ODP/TEFC