Sullair Series Ls-32 Specifications; Lubrication Guide- Standard Compressors; Lubrication Guide- 24Kt Compressors; Application Guide - Sullair LS-32 Operator's Manual And Parts List

3.1 SULLAIR SERIES LS-32 SPECIFICATIONS

60 HZ MODEL
(AC & WC)
50Hz MODEL
(AC & WC)
(I) Add 4 in./10 cm for enclosure. Add 27.5 in./70 cm for servicing the separator.
(II) For data on package weights, consult Sullair Factory Sales Department.
For noise level information, please contact the Sullair Factory Service Department.
3.2 LUBRICATION GUIDE- STANDARD COMPRES-
SORS
Refer to Figure 3-1. Sullair LS-32 Series standard
compressors are filled with Sullube fluid as factory
fill.
Mixing of other lubricants within the compres-
sor unit will void all warranties.
Sullube fluid should be changed every 8000 hours
or once a year, whichever comes first. The fluid
should be changed more frequently under severe
operating conditions, such as high ambient temper-
atures coupled with high humidity, or when high
particulate level, corrosive gases or strong oxidizing
gases are present in the air.
Maintenance of all other components is still recom-
mended as indicated in the Maintenance section of
this manual.

3.3 LUBRICATION GUIDE- 24KT COMPRESSORS

See Figure 3-1. Sullair 24KT compressors are filled
with a lubricant which rarely ever needs to be
changed. In the event a change of fluid or make-up
fluid is required, use only Sullair 24KT fluid.
Mixing of other lubricants within the compressor
unit will void all warranties.
Sullair recommends that 24KT sample be taken at
the first filter change and sent to the factory for
analysis. This is a free service. A sample kit with
instructions and self addressed container is to sup-
plied by your Sullair representative at start-up. The
user will receive an analysis report with recommen-
dations.
A 24KT sample should be sent in annually, after
the first year.
LENGTH
(IN)
175
LENGTH
(CM)
445
WIDTH HEIGHT (I)
(IN)
84
WIDTH HEIGHT (I)
(CM) (CM)
213

3.4 APPLICATION GUIDE

Sullair encourages the user to participate in a fluid
analysis program with the fluid suppliers. This could
result in a fluid change interval differing from that
stated in the manual. Contact your Sullair dealer for
details.
3.5 LUBRICATION CHANGE RECOMMENDATIONS
AND MAINTENANCE
LUBRICANT FLUID
CHANGE
Sullube A, D
24KT E, D
A - 8,000 Hours or once a year
B - When measured pressure loss exceeds 20 psig (1.3 bar).
C - When measured pressure loss exceeds 10 psig (0.7 bar).
D - When required by fluid analysis or known contamination.
E - Does not require replacement during normal service condi-
tions.
F- Every 1000 hours.
Figure 3-1 Fluid Fill Location
Section 3
SPECIFICATIONS
WEIGHT
(IN) (LB)
88 (II)
WEIGHT
(KG)
224 (II)
FLUID FILTER SEPARATOR
CHANGE CHANGE
F, B
F, B
A, C
A, C
21