Table of Contents
Advertisement
4. PHYSICAL INSTALLATION PROJECTOR
About this chapter
This chapter describes how the set up of the projector has to be done.
Overview
•
Positioning the DPxK BLP series projector at port window
•
Access to the power connection
•
Power input setup of the DPxK-36BLP
•
Connecting the DPxK-17/23BLP with the power net
•
Connecting the DPxK-36BLP with the power net
•
Power loop through to the projector electronics
•
Connecting a UPS to the projector electronics
4.1
Positioning the DPxK BLP series projector at port window
W
ARNING
General guide lines
•
Use a solid pedestal to put the DPxK BLP series projector on. Ensure that the pedestal can handle the weight of the projector
and that all feet of the projector are captured.
•
The pedestal should be placed in front of the port window wall in a manner that the projector front cover is at a minimum distance
of 20 centimeters from the port window.
Image 4-1
Positioning at port window
Barco offers a pedestal for the DPxK BLP-series projector. This universal pedestal allows a solid and easy
setup of the projector. The universal pedestal has a separate compartment to install the UPS unit (if available)
for the DPxK BLP-series projector. Futhermore, the universal pedestal contains a standard 19" rack to build
in the projector peripherals like alternative content switchers.
Necessary tools
•
14 mm wrench
•
17 mm wrench
Projector centering
1. If the projector is standalone in front of the port window, center the projector with the theatre screen (see ref A image 4-2).
R5906753 DPXK BLP SERIES 20/11/2017
:
The installation of the DPxK BLP series projector requires at least 4 persons.
20 cm
4. Physical installation projector
27
Advertisement
Table of Contents
