Icmp Communication Ports - Barco DP2K-36BLP User And Installation Manual

Dpxk blp series
Table of Contents

Advertisement

9. ICMP
HDD models validated by Barco
Only the original HDD spare parts provided by Barco or models validated by Barco (see list below) can be used in the ICMP. All
deviations from this rule void warranty.
List of validated models:
1TB: HGST – Western Digital (order code: HCC541010A9E630)
2TB: Seagate (order code : ST2000NX0253)
9.3

ICMP communication ports

Location of the communication ports
Image 9-6
ICMP (with HDMI 2.0).
Functionality
1
AUDIO-AES 1-8 (9-16)
ICMP outputs sixteen audio signals equitably distributed over these two RJ45 connectors, which can be configured
independently. The mapping of audio channels (content) on each audio output (AES outputs of the ICMP) is performed by
configuring the ICMP via the Communicator software. Please refer to the Communicator user guide for further information.
GPO 1-4 (5-8)
2
These RJ45 connectors can be used to send trigger signals to other devices. The mapping of user Cues (output Cues) on
each General Purpose Output (GPO) is configured via the Communicator software. Please refer to the Communicator
user guide for further information.
GPI 1-4 (5-8)
3
These RJ45 connectors can be used to receive trigger signals from other devices. The mapping of the General Purpose
Input (GPI) on each input Cues is configured via the Communicator software. Please refer to the Communicator user
guide for further information.
SYNC IN / OUT
4
Synchronization signal IN and OUT: Reserved for multiple-projector projection. Use a 50 Ohm coaxial cable to connect
the sync signal from projector to projector.
LAN 1 (2)
5
The ICMP can be connected to a LAN (local area network) using one of the Ethernet ports. These LAN port are used
for 'content' transfer.
NOTE: These ports are optionally used to connect to external content storage sources. Control of the ICMP is done via the
same IP address as the projector.
USB 2.0
6
The ICMP can be connected to a USB 2.0 Media to load content. The USB port can be used to load content (DCP) or
keys (KDM).
NOTE: It is recommended to use the USB 3.0 ports for faster ingest.
96
1
2
3
4
5
6
7
R5906753 DPXK BLP SERIES 20/11/2017

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dp2k-17blpDp4k-17blpDp4k-36blpDp2k-23blpDp4k-23blp

Table of Contents