Care Of Your Machine; Cleaning Upper Knife Area - Janome Stirling 8002D Instruction Manual

Care of Your Machine

e
0.8 – 1.5 mm (3/64˝)
r
w
e
AFTER SALES SUPPORT
1300 526 663
AUS
40
AUS Hotline Costs
r
w
q
q
Replacing the Upper Knife
To remove:
1. Turn off the power switch and unplug the
machine.
2. Open the looper cover and side cover.
3. Deactivate the upper knife.
4. Remove the hexagonal bolt, and remove the
upper knife.
q Upper knife
w Hexagonal bolt
e Stopper pin
r Lower knife
* Upper knife is available as a spare part (Refer to
page 44).
To attach:
1. Insert new upper knife into the groove of
knife holder and stopper pin, then tighten the
hexagonal bolt slightly.
2. Turn the upper knife holder to cutting position.
3. Turn the handwheel toward you until the upper
knife comes to its lowest position.
Loosen the hexagonal bolt, and adjust the
position of the upper knife so that the edge of
the upper knife overlaps 0.8 to 1.5 mm (3/64˝)
from the edge of lower knife as illustrated.
Tighten the hexagonal bolt firmly.
4. Close the looper cover and side cover.

Cleaning Upper Knife Area

1. Turn off the power switch and unplug the
machine.
2. Open the looper cover.
Remove the waste pieces to the front with a lint
brush or waste scraps.
* You may use a vacuum cleaner to clean the
upper knife area or feed dog.
* The lower knife will last over one year in normal
use. However, if you run over a pin or a hard
object, it may be required to replace both upper
and lower knives at the same time.
enquiries@esqaustralasia.com.au
MODEL: 8002D PRODUCT CODE: 52832 04/2016