Network Connection; Final Installation Process - Interlogix MobileView 3000 User Manual

Network Connection

This section describes the physical connection to an Ethernet network. This step
must be completed before the MobileView 3000 DVR can connect to the
network. There are two basic types of connection:
Direct PC Connection through Crossover Network Cable
The point-to-point connection of MobileView 3000 DVR and PC requires a
crossover (crossed) network cable. This type of connection is ONLY used for
direct connection to a single PC. Make sure that the PC is equipped with a
10/100 Mbps compatible network connection.
Figure 6: Direct PC Connection

Final Installation Process

Once you have completed the basic wiring connections, you are ready to turn on
the MobileView 3000 DVR. Simply plug in the power source. The power led will
light up if power is normal. Once the system has finished loading, you can begin
to set up the menu options for the MobileView 3000 DVR.
When the MobileView 3000 DVR is placed in an environment where the
Note:
temperature is under -0C°, the MobileView 3000 DVR will NOT turn on
immediately. The heater will heat up the MobileView 3000 DVR until the
temperature reaches -0C°. The MobileView 3000 DVR will only turn on when the
temperature is above -0C°.
MobileView 3000 User Manual 17