Yamaha Sirius T110LSE Service Manual page 61

ADJUSTING THE VALVE CLEARANCE
9Hold the adjusting screw to prevent it from
moving and tighten the locknut to specifica-
tion.
Locknut
7 Nm (0.7 m·kg, 5.0 ft·lb)
d. Measure the valve clearance again.
e. If the valve clearance is still out of specifica-
tion,repeat all of the valve clearance adjust-
ment steps until the specified clearance is
obtained.
LLLLLLLLLLLLLLLLLLLLLLLL
6. Install:
9camshaft sprocket cover
9O-ring
9timing check plug
(with O-ring)
9center plug
(with O-ring)
7. Install:
9tappet cover (intake side) 1
9O-ring 2
8. Install:
9tappet cover (exhaust side)
9O-ring
9. Install:
9front cowlings (left and right)
9center panel
Refer to "INSTALLING THE FRONT COWL-
INGS".
3-8
CHK
ADJ
7 Nm (0.7 m•kg, 5.0 ft•lb)
7 Nm (0.7 m•kg, 5.0 ft•lb)
18Nm (1.8 m•kg, 13 ft•lb)