Grassbox Instructions; Adjusting The Cutting Height - Flymo GLIDER G330 Original Instructions Manual

1. Start mowing the edge of the lawn nearest to the
power point so the cable is laid out on the lawn you
have already cut.
2. Mow twice a week during the growing season, your
lawn will suffer if more than a third of its length is cut
at one time and this may also result in poor collection.
Do Not Overload Your Mower
Mowing long thick grass may cause the motor speed to
G
1
H
K
L
How to Mow

Grassbox Instructions

Grassbox Full
1. As the grassbox fills up, grass will be clearly visible
2. The window will fill from left to right, when the window is
Emptying the Grass
• Stop the lawnmower, and wait until the blade has
1. Take hold of the grassbox handle and lift out, the lid will
2. Lift out grassbox and empty. (J)
3. Replace grassbox and the lid will close automatically.
• Failure to fit the grassbox and grassbox lid correctly will
Ensure there is no grass trapped in the inlet hole.
Spanner & Spacers
There is a spanner and additional spacers, for height ad-
justment, stored inside the lawnmower underneath the
grassbox.(K) These can be stored inside the lawnmower
even whilst it is use.

Adjusting the Cutting Height

drop, you will hear a change in the motor sound. If the
motor speed drops you may overload your lawnmower
which may cause damage. When mowing in long thick
grass a first cut with the cutting height set higher will
help reduce the load. See Adjusting the Cutting Height.
REMEMBER: For best grass collection always mow in a
straight line, do not swing the lawnmower from side to
side.
through the window in the grassbox (G1)
half full it is time to empty the grassbox (G)
stopped rotating BEFORE lifting the grassbox out.
open automatically (H)
cause poor grass collection.
J
Always handle the blade with care - sharp edges could
cause injury. USE GLOVES. Never use more than 3
Cutting Height Spacers. Spacers must only be fitted
between the blade and the fan and NEVER between the
blade and the bolt.
1. Remove the blade bolt, and blade as described in
Removing the Blade and Fan.
2. For a Lower Cut - Add spacers to a maximum of 3.
3. For a Higher Cut - Take spacers away.
4. Refit the blade as described in Fitting the Blade and
Fan.