Configuring The Conference Codes; Adjusting The Flash/Recall Pulse - Avaya B159 Series User Manual

7.5 Configuring the Conference Codes

To automate multiparty conferencing, the phone needs to be configured with codes that match those expected by the
telephone system to which it is connected. For example, by default IP Office systems use the system short code *47 to
let a user conference together their current and held calls.
In the actions below:
· To enter F, press the
· To backspace, press the
To set the phone's conference signalling settings:
1. Select > CONF GUIDE > SETTINGS.
2. At the ENQUIRY prompt, enter the command the telephone system uses to hold the current call and press OK.
For IP Office, enter F and press OK.
3. At the CONFERENCE prompt, enter the command the telephone system uses to conference your held and current
calls together and press OK. For IP Office, enter F*47 and press OK.
4. At the RETURN prompt, enter the command your telephone system uses to switch between calls and press OK.
For IP Office, enter F and press OK.

7.6 Adjusting the Flash/Recall Pulse

The Flash/Recall signal sent when
to which the telephone is connected. Typically the length of the signal required varies between different countries and so
must be set correctly.
To set the phone's flash/recall pulse width:
1. Select > SETTINGS > FLASH.
2. Select your choice. Examples of settings are:
· 100ms = Scandinavia, Europe, Siemens HiPath
· 300ms = Germany, France, Israel
· 500ms = USA
3. Press OK to confirm.
B159 Series User Guide
IP Office™ Platform 10.0
button.
button.
is pressed during a call. It is used to request a new line from the telephone system
Comments on this document? infodev@avaya.com
Page 38
Issue 02a (06 November 2017)