Sds Remote Control; Setting Remote Control; Setup; Ring Style - Motorola MTP3100 User Manual

68015000897–FC
Chapter 4: Main Menu
NOTICE: If the sending Individual Short Subscriber Identity (ISSI) is not on the Allowed ISSIs
list, the receiving radio ignores the task.
4.6.7.2

SDS Remote Control

NOTICE: This feature is a paid feature.
NOTICE: Only one type of remote control can be active on a radio; either SDS or Status.
SDS Remote Control is a feature that enables remote control and configuration of the radio via special
SDS messages. The messages can be sent both in TMO and DMO (including the Repeater Mode) by
any radio capable of controlling other radios. During the execution of the Remote Control messages,
depending on your service provider settings, the radio can play a tone or display an appropriate icon in
the status icon area.
4.6.7.3

Setting Remote Control

This procedure describes how to toggle remote control.
Procedure:
1 From the home screen, press the Menu key.
2 Select Security → Remote Control.
3 Select On to enable, or Off to disable remote control.
4.7

Setup

This sub-menu allows you to change your radio configuration.
4.7.1

Ring Style

This sub-menu allows you to set the incoming call ring style.
4.7.1.1

Setting Ring Style

Procedure:
1 From the home screen, press the Menu key.
2 Select Setup → Ring Style.
3 Select one of the following:
• Duplex – to set the new ring style to all duplex calls.
• Simplex – to set the new ring style to all simplex calls.
NOTICE: Upon entry into this sub-menu, the display shows the current ring style used.
4 Scroll to the desired style and press Select.
76 Send Feedback