Table of Contents
Advertisement
5. If no firmware will be sent during 1 minute, or in case of an error, the firmware update will
fail and return to the previous operation mode.
6. The firmware update process will take about 10 minutes.
7. A successful update will result in an appropriate message
8. To apply the new firmware, the camera should be power cycled.
9.4 Connect and configure the JetCam
The Vision Point Application allows to connect and configure the Frame Grabber and the connected
JetCam camera. The basic steps include:
1. Selecting a grabber board
2. Opening, creating and closing a project
3. Adjusting the grabber parameters
4. Scanning and adjusting the camera parameters
5. Starting an image acquisition
Different Frame Grabber boards may include different feature sets. The target board is selected from
the combo box and is only available when there is no active project mounted. If a different target
board to be selected, the active project should be closed first.
To select a target board:
Click the
When the list of available target boards will open, select the required board/demo mode from
the list.
Click "Create new project" to create new project from scratch or "Open existing project..." to
open an existing one.
High Speed Camera User Guide
button of the grabber selection combo box located on the Toolbar Menu.
Using JetCam Camera
31
Advertisement
Table of Contents
