Figure 5 : Jet Camc - Kaya Instruments JetCam19 User Manual

Figure 3 : QSFP+ Module with
fiber cable inserted
:
NOTES
1. A fiber cable should match the QSFP+ type. If a single mode QSFP+ is used a single mode
fiber (yellow) should be used with it. If a multi-mode QSFP is used a multi-mode fiber
(orange) should be used.
2. The Fiber cable is connected between TX output (marked with TX or Arrow outwards the
QSFP+) on JetCam unit and RX input (marked with RX or Arrow inwards the QSFP+) on
Komodo Fiber frame grabber.
3. If more than a single cable is used to connect to the same Frame Grabber, the cables must be
of the same type and length.
JetCam Camera
High Speed Camera User Guide
(up to 10 km)
Power
supply
Figure 5 : JetCam Camera connection example
Installation and Configuration
Figure 4 : QSFP+ Module's locking
Fiber cable
mechanism
Komodo Fiber
Frame Grabber
18