Jetcam Power Connector; Figure 7 : Jetc - Kaya Instruments JetCam19 User Manual

The QSFP+ LED's behavior is described in Table 4:
LED state
Fast flash red
Solid red
Slow pulse red
Fast flash green
Solid green

7.1.2 JetCam Power Connector

The JetCam unit requires 12V power supply for proper function. Please, refer to Electrical
specification section of this document for exact Power Supply requirements.
The positive pin of the power supply connected to the right pin of the connector, shown as "+",
the negative pin connected to the left pin of the connector, shown as "-". The power connector is
shown in Figure 7.
NOTE:
Powering up the camera will automatically start SDI transmission for local camera configuration.
Detecting the camera using Vision Point application will turn off the SDI output and the image
will be displayed only via Vision Point application interface. For SDI output, the camera should
be powered cycle.
High Speed Camera User Guide
QSFP+ is unplugged
QSFP is not compatible
No signal detected on optic fiber
Link speed is being negotiated
Link is active
Table 4 : QSFP+ status LEDs behavior
Power
Connector
Figure 7 : JetCam camera power connector
Condition
- +
Hardware Reference
20