Table of Contents
Advertisement
9.1 Getting Started
The Vision Point application is the main interface for all camera setting and configurations.
9.2 JetCam Terminal control
A Mini USB port is available for individual link & general information status and firmware update.
The port uses a Silabs CP2101 chip. A driver from the Silabs website might have to be installed on
certain PCs to gain access to the terminal port. Free supporting driver can be found at:
http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx
After driver installation and USB connection is acquired a serial emulated terminal (i.e Tera Term
use is recommended) can be used with the following configurations, described in Table 14:
Baud rate
Start bits
Stop bits
Parity
Flow Control
The following commands are supported by the terminal; each command must be followed by carriage
return (Enter) in order to execute:
Command
Firmware
Status
NOTE: The commands are not case sensitive.
High Speed Camera User Guide
Parameter
Table 14 : Serial emulated terminal configurations
Description
Sets the system to firmware update mode. See 9.3 chapter for firmware
update information
Prints the system and individual link status and general information
Table 15 : Terminal commands
Using JetCam Camera
9
Value
115200
1
1
None
None
29
Advertisement
Table of Contents
