Listening To The Fm Radio - JVC UX-G290D Instruction Manual

Listening to the FM Radio

• AM broadcast cannot be received on this System.
• For DAB operations, see pages 12 to 14.
1
Select FM.
2
Tune in to a station.
1 sec.
Station searching starts and frequency indication starts
changing on the display.
When a station (frequency) with sufficient signal strength
is tuned in, the searching will stop.
• When you press the button repeatedly, the frequency
changes step by step.
To stop searching manually, press either button.
If the received FM station is hard to listen
The STEREO indicator goes off.
Reception will improve though stereo effect is lost.
To restore the stereo effect
Press DAB/FM/AUDIO IN to select "FM".
7
To preset the stations
You can preset 20 FM stations.
1
Tune in to an FM station you want to preset.
2
Activate the preset number entry mode.
• Finish the following process while the indication on the
display is flashing.
3
Enter a preset number for the station you want to
store.
•
You can also use PRESET
4
Store the station.
To tune in to a preset station
Enter a number of the preset station you stored.
• You can also use PRESET
MHz
• To enter preset number 5,
press 5.
• To enter preset number 15,
10 → 1 → 5.
= >
press
• To enter preset number 20,
10 → 2 → 0.
= >
press
/
1 y .
• To enter preset number 5,
press 5.
• To enter preset number 15,
10 → 1 → 5.
= >
press
• To enter preset number 20,
10 → 2 → 0.
= >
press
/ .
1 y