Adjust Bgp Timers - Cisco NCS 5500 Series Configuration Manual

Implementing BGP
end-policy
router bgp 65000

Adjust BGP Timers

BGP uses certain timers to control periodic activities, such as the sending of keepalive messages and the
interval after which a neighbor is assumed to be down if no messages are received from the neighbor during
the interval. The values set using the timers bgp command in router configuration mode can be overridden
on particular neighbors using the timers command in the neighbor configuration mode.
Perform this task to set the timers for BGP neighbors.
SUMMARY STEPS
1. configure
2. router bgp as-number
3. timers bgp keepalive hold-time
4. neighbor ip-address
5. timers keepalive hold-time
6. commit
else
drop
endif
bgp fast-external-fallover disable
bgp confederation peers
65001
65002
bgp confederation identifier 1
bgp router-id 1.1.1.1
address-family ipv4 unicast
aggregate-address 10.2.0.0/24 route-policy set_next_hop_agg_v4
aggregate-address 10.3.0.0/24
redistribute static route-policy set_next_hop_static_v4
address-family ipv6 unicast
aggregate-address 2012::/64 route-policy set_next_hop_agg_v6
aggregate-address 2013::/64
redistribute static route-policy set_next_hop_static_v6
neighbor 10.0.101.60
remote-as 65000
address-family ipv4 unicast
neighbor 10.0.101.61
remote-as 65000
address-family ipv4 unicast
neighbor 10.0.101.62
remote-as 3
address-family ipv4 unicast
route-policy pass-all in
route-policy pass-all out
neighbor 10.0.101.64
remote-as 5
update-source Loopback0
address-family ipv4 unicast
route-policy pass-all in
route-policy pass-all out
BGP Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.2.x
Adjust BGP Timers
7