Configuring Evpn-Vpws - Cisco NCS 5500 Series Configuration Manual

EVPN Virtual Private Wire Service (VPWS)
Step 3
address-family l2vpn evpn
Example:
RP/0/RP0/CPU0:router(config-bgp)# address-family l2vpn evpn
Specifies the L2VPN address family and enters address family configuration mode.
Step 4 neighbor ip-address
Example:
RP/0/RP0/CPU0:router(config-bgp)# neighbor 10.10.10.1
Adds the IP address of the neighbor in the specified autonomous system.
Step 5 address-family l2vpn evpn
Example:
RP/0/RP0/CPU0:router(config-bgp-nbr-af)#
Specifies the L2VPN address family of the neighbor and enters address family configuration mode.
Step 6 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.

Configuring EVPN-VPWS

Perform this task to configure EVPN-VPWS.
SUMMARY STEPS
1. configure
2. interface type interface-path-id
3. l2vpn
4. xconnect group group-name
5. p2p xconnect-name
6. interface type interface-path-id
7. neighbor evpn evi vpn-idtarget ac-id source ac-id
8. Use the commit or end command.
address-family l2vpn evpn
BGP Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.2.x
Configuring EVPN-VPWS
149