Table of Contents
Advertisement
3 Use the red and white AV Cable connectors to connect audio from the
S-Video source to the projector. See connecting Non-Computer Audio,
below.
CONNECTING NON-COMPUTER AUDIO
The AUDIO ports allow you to connect stereo or monaural audio from a
composite video source.
Figure 2-16 Audio Input ports
For stereo audio, use the supplied AV cable.
1 Insert the red (right) and white (left) ends of the cable into the Audio Out
ports of a composite video's audio source.
2 Connect the other end of each cable to the projector's AUDIO IN ports.
NOTE: Although two COMPUTER AUDIO sources and two other AUDIO
sources may be connected simultaneously, only one can be active. If
computer video is selected, COMPUTER AUDIO is active. If NTSC, PAL,
SECAM, or S-VHS video are being viewed, AUDIO is active.
If your audio source is monaural, connect it to the left AUDIO port.
2-12
Chapter Two
Advertisement
Table of Contents
