Proxima DP5500 User Manual page 18

Connecting Macintosh Computers
Use the video adapter cable shown below to connect a Macintosh computer
to the DP5500.
From
Mac CPU
Figure 2-10 The Macintosh adapters
Use the cable adapter and supplied VGA video cable to connect the
projector to your Macintosh computer.
Figure 2-11 Macintosh connections
1 Unplug the Macintosh monitor cable from the computer.
2 Plug one end of the supplied VGA video cable into the RGB IN 1 port on
the projector. Attach the VGA end of the Mac - VGA cable adapter to the
other end of the VGA video cable.
3 Plug the Mac end of the Mac - VGA cable adapter into the Macintosh
video port.
4 Connect the audio source to the projector's AUDIO IN 1 port
(see page 2-10).
NOTE: If you are using a second computer video or audio source, plug their
outputs into the RGB IN 2 and AUDIO IN 2 connectors.
2-8 Chapter Two
Mac – VGA Cable Adapter
Mac - VGA
Cable Adapter
VGA Cable
Computer 1
Macintosh
Monitor Cable
To Monitor Out Port
to
In Port
VGA - Mac
Monitor Cable
To VGA
Cable