20
Chapter 1 Hardware Installation
Figure 2 Rear Panel
2
3
4
214853-B
Console
Port
Connect the Console Port – Connect the console cable to the RS-232 console
port for accessing the command-line interface. (Refer to "Run Time Console
Specifications" for complete information on the CLI.) You can manage the
access point through this console connection, or the Web management
interface (refer to
"System Configuration" on page
Connect the Ethernet Cable – The Access Point 2220/2221 can be connected
to a wireline network via a 10 or 100 Mbps Ethernet connection. Connect a
Cat 5 (or higher) UTP cable between the Access Point 2220/2221 and another
network device such as a hub or switch.
If you are not using PoE, use the separately orderable power adapter –
Connect the power adapter cable to the 5 VDC power socket on the rear panel.
Warning: Use ONLY the power adapter supplied by Nortel Networks for
this product. Otherwise, the product may be damaged. Contact your
Nortel Networks representative to order the power adapter.
5 V DC
RJ-45
Power Socket
Connector
(PoE)
24.)