2-4. Using other driving systems
Approach warning
When your vehicle is too close to a vehicle ahead, and sufficient auto-
matic deceleration via the cruise control is not possible, the display will
flash and the buzzer will sound to alert the driver. An example of this
would be if another driver cuts in front of you while you are following a
vehicle. Apply the brakes to ensure an appropriate vehicle-to-vehicle dis-
tance.
Dynamic radar cruise can be set when
■
The shift lever is in D. (Recommended)
●
Dynamic radar cruise control can also be set when the shift lever is in the S posi-
tion and range 4, 5 or 6 has been selected.
Vehicle speed is above approximately 30 mph (50 km/h).
●
Switching modes
■
The mode cannot be switched to constant speed control mode if vehicle-to-vehicle
distance control mode has been used. The mode also cannot be switched from
constant speed control to vehicle-to-vehicle distance control mode. Turn the sys-
tem off by pressing the "ON-OFF" button, and turn it on again.
Accelerating
■
The vehicle can be accelerated normally. However, during vehicle-to-vehicle dis-
tance control mode, the vehicle speed may decrease below the set speed in order
to maintain the distance to the vehicle ahead.
254
GX460_U.S.A. (OM60G24U)