Extreme Networks Summit X150-24t Hardware Installation Manual page 92

Confidential and proprietary information of Extreme Networks. © 2011 Extreme Networks, Inc.
Installing Summit Family Switches
To rack-mount a Summit switch:
1 Place the switch upright on a stable work surface.
2 Place a mounting bracket over the mounting holes on one side of the unit.
3 Insert the screws and fully tighten with a suitable screwdriver, as shown in
Figure 134: Attaching the Mounting Bracket
Summit X350, X450, X450a,
and X450e, series
4 Repeat steps 2 and 3
5 Slide the switch into the rack
Take care to load the rack so that it is not top-heavy. Start installing equipment at the bottom of
G
the rack and work up.
Do not cover vents that would restrict airflow. Leave half a rack space between the units for
G
adequate ventilation.
Figure 135: Installing a Switch in a Rack
'
6 Secure the switch with suitable screws (not provided).
7 Connect the switch to the redundant power supply (if applicable). For instructions to install and
connect redundant power supplies, see
186
All rights reserved. DRAFT. October 20, 2011
34
35
S450_007
for the other side of the switch.
(Figure 135).
SH_236_X450
Chapter 2, "Summit Power Supplies."
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
49 X
Summit X150 and X250e series
Summit Family Switches Hardware Installation Guide
Figure 134.
50 X
SH_245_S150