Table of Contents
Advertisement
Approvals
– "Industrial Ethernet / PROFINET Industrial Ethernet" System Manual
– "Industrial Ethernet / PROFINET - Passive network components" System Manual
– "EMC Installation Guidelines" configuration manual
Note
The test was performed with a device and a connected communications partner that also
meets the requirements of the standards listed above.
When operating the device with a communications partner that does not comply with
these standards, adherence to the corresponding values cannot be guaranteed.
Current approvals on the Internet
RUGGEDCOM products are regularly submitted to the relevant authorities and approval
centers for approvals relating to specific markets and applications.
You will also find the current approvals for the product on the Internet pages of Siemens
Automation Customer Support under the following entry ID:
80046561 (http://support.automation.siemens.com/WW/view/en/80046561/134200)
→ "Entry list" tab, entry type "Certificates"
National approvals
You will find an overview of the country-specific wireless approvals of RUGGEDCOM
devices with GSM or UMTS services on the Internet pages of Siemens Automation
Customer Support. You will find the link to the document on the following page:
ik-Info (www.siemens.com/simatic-net/ik-info)
46
●
Keep to the installation guidelines
The devices meet the requirements if you adhere to the installation and safety
instructions contained in this documentation and in the following documentation
when installing and operating the devices.
●
You can always find the latest documentation on the Internet
The current descriptions of the currently available products can always be found on
the Internet under the specified entry IDs/Internet pages:
You will find information on the system manuals in the section "ID = 27069465
(http://support.automation.siemens.com/WW/view/en/27069465)", in "Further
documentation".
ID = 60612658 (http://support.automation.siemens.com/WW/view/en/60612658)
●
Working on the device
To protect the device from electrostatic discharge, personnel must first discharge
any electrostatic charge from their body before touching the device.
RUGGEDCOM RM1224
Operating Instructions, 10/2016, RC1260-EN-02
Advertisement
Table of Contents
