Maintenance; Maintenance Schedule - Husqvarna RC 318T Operator's Manual

Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.

Maintenance schedule

* = General maintenance done by the operator. The
instructions are not given in this operator's manual.

Maintenance

Make sure that nuts and screws are tightened
Make sure that there are no fuel or oil leaks
To clean the product on page 20
Clean as given in
Clean under the cutting deck
Clean around the muffler
Make sure that the engine cooling air intake is not blocked
Make sure that the hydraulic oil cooler is not blocked, RC 320Ts
AWD model only
Make sure that the safety devices are not defective
Examine and test the brakes
Make sure that the sensor for collector full works correctly
Do a check of the engine oil level
Do a check of the oil level in the transmission
Do a check of the steering wires
Examine the blades in the cutting deck
Clean the cutting deck, under the belt covers and under the cutting
deck
Examine the headlights
Make sure that the tire pressure is correct
Do a check of the parking brake
Change the engine oil
Change the oil filter
Clean the air filter
Change the air filter
Change the fuel filter
Do a check of the parallelism of the cutting deck
63 - 007 - 20.06.2017
Maintenance
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an authorized service agent do the
maintenance.
Note: If more than one time interval is marked in the
table, the shortest time interval is for the first
maintenance only.
Daily maintenance
before operation
*
*
X
X
X
X
X
X
*
X
X
X
X
Maintenance interval
in hours
25 50 100 200
X
X
X X
X X
X
X
X
X
X
X
X X
19