Storage; Disposal; Technical Data; To Tow The Product - Husqvarna RC 318T Operator's Manual

To tow the product

The product is has a hydrostatic transmission. To
prevent damage to the transmission, tow the product
short distances only and at low speed.
Disengage the transmission when you tow. See
engage and disengage the drive system on page 15 .

Storage

At the end of the season, or if you let the product stay
idle for more than 30 days, it must be prepared for
storage. If you let fuel stay in the fuel tank for long
periods (30 days or more), tacky particles can cause
blockage in the carburetor and cause interference with
the engine.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline (Aspen) is used, stabilizer
is not necessary. If you use standard gasoline, do not
change to alkylate gasoline since sensitive rubber parts
can become hard. Add stabilizer to the fuel in the tank or
in the container used for storage. Always use the mixing
ratios given by the manufacturer. Run the engine for a
minimum of 10 minutes after you add the stabilizer until
it flows into the carburetor.
WARNING: Do not store the product with
fuel in the tank in an indoor location or in
locations with bad airflow where fuel fumes
can come in contact with open flames,
sparks, or a pilot light such as in a boiler, hot
water tank, clothes drier, etc.
WARNING: Remove grass, leaves and other
flammable materials from the product to
decrease the risk of fire. Let the product
become cool before you put it in storage.
• Clean the product, see
prevent corrosion.

Technical data

Dimensions
Length without cutting deck, mm
Width without cutting deck, mm
Length including cutting deck, mm
Width including cutting deck, mm
Height, mm
Weight without cutting deck, with empty tanks, kg
Weight including cutting deck, with empty tanks, kg
32
To
. Touch-up paint damage to
Technical data
• Examine the product for worn or damaged parts and
tighten loose screws and nuts.
• Charge the battery. Use only the charger specified
by Husqvarna for this type of battery (LiFePO4).
• Change the engine oil, and discard the waste oil.
• Empty the fuel tank. Start the engine and run it until
there is no remaining fuel in the carburetor.
Note: Do not empty the fuel tank and carburetor if a
stabilizer has been added.
• Remove the plugs and put about a tablespoon of
engine oil into each cylinder. Manually turn the
engine shaft to distribute the oil and screw the plugs
back on.
• Lubricate all grease nipples, joints and axles.
• Store the product in a clean and dry area and cover
it for more protection.
• A cover for protection of your product during storage
or transport is available at your dealer.

Disposal

• Used engine oil, antifreeze etc. is dangerous and
must not be discarded on the ground or in nature.
Always discard used chemicals at a service center or
an applicable disposal location.
• When the product is worn out and no longer used,
send it back to the dealer or to an applicable
recycling location.
• Be careful with oil, oil filters, fuel and the battery,
because of the possible effects on the environment.
Obey the local recycling requirements and applicable
regulations.
• Do not discard the battery as domestic waste.
• Send the battery to a Husqvarna service agent or
discard it at a disposal location for used batteries.
RC 318T
2089
1030
2394
1176
1284
326
389
RC 320Ts AWD
2089
1030
2394
1176
1284
327
390
63 - 007 - 20.06.2017