Troubleshooting; Troubleshooting Schedule - Husqvarna RC 318T Operator's Manual

Troubleshooting schedule

If you cannot find a solution to your problems in this
owner's manual, speak to your Husqvarna service
agent.
Problem
The starter motor does not turn
the engine over
The engine does not start when
the start motor turns the engine
over
The engine does not run smooth-
ly
The engine apparently has no
power
The transmission does not have
sufficient power
30

Troubleshooting

Cause
The parking brake is not applied. See
The lift lever for the cutting deck is in mowing position. See
page 9 .
The main fuse is blown. See
The ignition lock is defective.
The connection between the cable and the battery is bad. See
page 11 .
The battery is too weak. See
The starter motor is defective.
There is no fuel in the fuel tank. See
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburettor or fuel line.
The spark plug is defective.
The carburettor is incorrectly set.
The air filter is clogged. See
The fuel tank vent is blocked.
There is dirt in the carburetor or fuel line.
The air filter is clogged. See
The spark plug is defective.
There is dirt in the carburetor or fuel line.
The throttle cable is incorrectly adjusted.
The transmission cooling air intake or the cooling flanges are blocked.
The fan on the transmission is damaged.
The hydraulic oil cooling fan (RC 320Ts AWD only) is blocked. See
hydraulic oil cooler on page 21 .
The hydraulic oil cooling fan (RC 320Ts AWD only) is damaged.
There is no oil in the transmission or the oil level is too low. See
of the transmission oil level on page 29 .
Safety circuit on page 9 .
To replace a fuse on page 24 .
To charge the battery on page 24 .
To fill fuel on page 14 .
To clean and change the air filter on page 23 .
To clean and change the air filter on page 23 .
Safety circuit on
Battery safety on
To clean the
To do a check
63 - 007 - 20.06.2017