Stereo Gate - Korg Pa4X User Manual

Stereo Gate

This effect mutes the input signal when it falls below a specified level. You
can also invert the on/off status of the gate, or use note-on/off messages to
turn the gate on/off directly.
Stereo In - Stereo Out
Left
Envelope Source
+
Envelope Select
D
-mod
Right
FX Control BUS 1
FX Control BUS 2
a Envelope Source
b Envelope Select
Src
c Threshold
Polarity
d Attack
Release
e Delay Time [msec]
f Side PEQ Insert
Trigger Monitor
g Side PEQ Cutoff [Hz]
Q
Gain [dB]
Delay
Side PEQ
Envelope - Control
Envelope - Control
Delay
D-mod, Input
L/R Mix,
L Only,
R Only
Off...Tempo
0...100
+, –
1...100
1...100
0...100
Off, On
Off, On
20...12.00k
0.5...10.0
–18.0...+18.0
Effect parameters |667
FX Amt
Gain Adjust
Gate
Trigger Monitor
Gate
Gain Adjust
FX Amt
Selects the source to control the gate:
D-mod control, or use the input signal as
a trigger
Selects the control signal: left and right
linked, left only, or right only
Selects the source that will control the
gate when Envelope Src = D-mod
Sets the level at which gating is applied
Switches the polarity of gating
Sets the attack time
Sets the release time
Sets the delay time for the gate input
Switches the trigger signal equalizer on/
off
Switches between monitoring the effect
output and the trigger signal
Sets the center frequency of the equal-
izer for the trigger signal
Sets the bandwidth of the equalizer for
the trigger signal
Sets the gain of the equalizer for the trig-
ger signal