Stereo Limiter - Korg Pa4X User Manual

Stereo Limiter

The Limiter regulates the input signal level. It is similar to the Compressor,
except that the Limiter compresses only signals that exceed the specified
level to lower unnecessary peak signals. The Limiter applies a peaking-type
EQ to the trigger signal (which controls the degree of the Limiter effect), al-
lowing you to set any band width to be covered. This effect is a stereo limiter.
You can link left and right channels, or use each channel individually.
Stereo In - Stereo Out
Left
Side PEQ
+
Envelope Select
Envelope Source
Right
FX Control BUS 1
FX Control BUS 2
a Envelope Select
b Ratio
c Threshold [dB]
v Attack
Release
e Gain Adjust [dB]
Src
Amt
f Side PEQ Insert
Trigger Monitor
Limiter
Envelope - Control
Trigger Monitor
Envelope - Control
Limiter
L/R Mix, Selects from linking both channels,
L Only, R Only, controlling only from left channel,
L/R Individually only from the right channel, or con-
trolling each channel individually
1.0 : 1... Sets the signal compression ratio
50.0 : 1,
Inf : 1
–40...0 Sets the level above which the com-
pressor is applied
1...100 Sets the attack time
1...100 Sets the release time
–Inf, –38...+24 Sets the output gain
Off...Tempo Selects the modulation source for the
output gain
–63...+63 Sets the modulation amount of the
output gain
Off, On Toggles between on/off of the trigger
signal's EQ
Off, On Switches between effect output moni-
tor and trigger signal monitor
Effect parameters |661
FX Amt
Gain Adjust
Gain Adjust
FX Amt