Reverb Dry Plate - Korg Pa4X User Manual

Reverb Dry Plate

This plate reverb simulates dry (light) reverberation.
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out
Left
EQ Trim
LEQ HEQ
+
EQ Trim
Right
a Reverb Time [sec]
High Damp [%]
b Pre Delay [msec]
Pre Delay Thru [%]
c EQ Trim
d Pre LEQ Fc
Pre HEQ Fc
e Pre LEQ Gain [dB]
Pre HEQ Gain [dB]
f Wet/Dry
Src
Amt
b: Pre Delay [msec]
b: Pre Delay Thru [%]
The "Pre Delay" sets the delay time to the reverb input, allowing you to con-
trol spaciousness.
Pre Delay Thru
Reverb
Pre Delay
0.1...10.0 Sets the reverberation time
0...100 Sets the damping amount in the high range
0...200 Sets the delay time from the dry sound
0...100 Sets the mix ratio of non-delay sound
0...100 Sets the EQ input level
Low, Selects the cutoff frequency (low or mid-
Mid-Low low) of the low-range equalizer
High, Selects the cutoff frequency (high or mid-
Mid-High high) of the high-range equalizer
–15.0...+15.0 Sets the gain of Low EQ
–15.0...+15.0 Sets the gain of High EQ
Dry, Balance between the wet and dry signal
1:99...99:1, Wet
Off...Tempo See DMS (Dynamic Modulation Source)
–100...+100 Amount of modulation source
Effect parameters |567
FX Amt
FX Amt