Parts Removal For Cleaning/Sanitizing; Single Evaporator Ice Machines; Remove The Water Curtain; Remove The Ice Thickness Probe - Manitowoc SD0302A Technician's Handbook
S series;
s300 series;
s420 series;
s450 series;
s500 series;
s850 series;
s1000 series;
s1200 series;
s1400w series;
s1400a series;
s1400n series;
s1800w series;
s1800a series;
s1800n series
Hide thumbs
Also See for SD0302A:
- Technician's handbook (301 pages) ,
- Service manual (168 pages) ,
- Installation, use & care manual (68 pages)
Table of Contents
Advertisement
Downloaded from
www.Manualslib.com
PARTS REMOVAL FOR CLEANING/SANITIZING
Single Evaporator Ice Machines
A. Remove the water curtain
•
Gently flex the curtain in the center and remove it
from the right side.
•
Slide the left pin out.
B. Remove the ice thickness probe
•
Compress the hinge pin on the top of the ice
thickness probe.
•
Pivot the ice thickness probe to disengage one pin
then the other. The ice thickness probe can be
cleaned at this point without complete removal. If
complete removal is desired, disconnect the ice
thickness control wiring from the control board.
C. Remove the water trough
•
Depress tabs on right and left side of the water
trough.
•
Allow front of water trough to drop as you pull
forward to disengage the rear pins.
NOTE: Proceed to page 37, Step 7.
A.
34
manuals search engine
C.
Part Number 80-1479-3 7/10
B.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
